DONE! Item Has Been Added To Your Cart

Your Cookies Are Disabled!

Our site uses first-party Cookies which must be enabled or you will not be able to use the shopping cart. These Cookies are not for ad tracking, are anonymous and have no personally identifiable data - they only hold cart data. [How To Enable]

Top Seller
Rosco

Tough Prime Black 5 gl

by
(0 Review/s) Write a Review

$355.00

TL Item#: 72541 MFR Part#: 150060550640 Category: Theatrical Paint

Suggested Use: Use Tough Prime to prepare almost any surface for painting. Tough Prime can be used to prime Vinyl Projection Screen and Dance Floor, even carpet. Tough Prime Black is perfect for stage floors and proscenium arches, resisting scuffs and abrasions while providing a rich black finish.

Finish:
White: Satin
Black: Egg-Shell

Solvent: Water

Binder Type: Acrylic polymer

Dilution: Use Tough Prime undiluted for most applications. When applying by brush, it may be necessary to dilute with water to achieve the proper viscosity.

Surface Preparation: Surfaces should be clean, dry and free from dirt and grease. If painting over an existing paint finish, remove any loose material with a brush. When painting over solvent based finishes, or high gloss surfaces, use fine sandpaper or steel wool to give the surface more tooth. Be sure to remove all sanding dust for best adhesion.

Application: Stir contents before use. Do not shake. Apply by brush, roller, or spray gun. Apply in even, uniform coats, using a good quality brush or roller. Use overlapping strokes, keeping a wet edge. Change roller direction often to avoid patterns and streaking. Do not apply a heavy coat. To build up a more durable finish, apply several thin coats, allowing each to dry thoroughly between applications.

Compatibility: Tough Prime is compatible with Rosco Scenic Paints and most other paints as well. Always test before using if unsure. Tough Prime can be tinted using Supersaturated Rosco Scenic Paint, colorants and other water-based paints.

Film Thickness: 3 mil. Dry Film

Coverage: Approximately 300 sq. ft. per gallon (28 sq. m. per 3.79L), depending on application method and substrate.

Avg. Dry Time: AT 75°F (24°C) Dries to the touch in 30-45 minutes. Can be re-coated in 1-2 hours.

Clean-Up: Soap and water.

Shelf Life: Minimum 24 months.

Packaging: 1 Gallon and 5 Gallon (3.79L and 18.95L).

Do not apply when surface or air temperatures are below 50°F (10°C). Keep from freezing. Avoid prolonged contact with skin or breathing of spray. Do not take internally. Use adequate ventilation. KEEP OUT OF REACH OF CHILDREN.

All technical data, recommendations and service are accurate to the best of our knowledge. Rosco assumes no responsibility for the results obtained or damage incurred from use by the buyer in whole or in part since method of application and its use is beyond our control.

NOTE: While Techland takes steps to ensure accuracy in it's product listings and images, any color samples or lamp and product images shown on this website are for reference only, may not be exact and may vary from the actual product look and/or color.

Tell A Friend About: Tough Prime Black

Share this great product and savings with others. Note: You and your friend's email addresses are only used once for this recommendation. We do not collect nor store the email addresses.

See all products by Rosco

2420 Center St, Suite 100, Houston TX 77007 | United States | 832-518-5583

🇺🇸 We Are Closed for the Memorial Day Holiday

Our storefront will be closed on Saturday the 27th & Monday the 29th in observance of the Memorial Day holidays.