Polygel® 35 is a self-thickening, brush-on polyurethane liquid mold rubber designed for making thin, stretchy brushed molds. When Part A & Part B are mixed together, the rubber self-thickens to a creamy consistency ideal for making molds on vertical and overhead surfaces. Mold makers often apply the first layer of Polygel® 35 without any additional thickener and then add PolyFiber II Thickeners to subsequent layers. A sprayable version of Polygel® is also available in a Shore A35 hardness (Polygel® Spray 35)

Technical Specifications

• Mix Ratio by Volume: 1A:1B
• Mix Ratio by Weight: 1A:1B
• Shore Hardness: A35
• Working Time: 10-15 min.
• Demold Time: 16 hr.
• Cured Color: Light Blue
• Specific Volume: 27.5 in³/lb
• Specific Gravity: 1.02
• Elongation: 620 %
• Tensile Strength: 436 psi
• Die C Tear Strength: 70 pli
• Notes: The color of polyurethane Part Bs may change in color from batch to batch or may darken with age, but product performance is not affected.
• Foundry Waxes: Certain foundry waxes can cause excessive oiling in Polygel rubbers; this is the case when liquid Polygel is applied to the foundry wax and when the foundry wax is poured into cured Polygel molds. Perform a small test cure to ensure compatibility.

WARNING: This product can expose you to chemicals including Toluene diisocyanate (TDI), which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.

FOR INDUSTRIAL/PROFESSIONAL USE ONLY.