DONE! Item Has Been Added To Your Cart

Your Cookies Are Disabled!

Our site uses first-party Cookies which must be enabled or you will not be able to use the shopping cart. These Cookies are not for ad tracking, are anonymous and have no personally identifiable data - they only hold cart data. [How To Enable]

PolyTek

Pol-Ease 2750 Latex Release 8 lb

by
(0 Review/s) Write a Review

$23.00

TL Item#: 107562 Category: Mold Making & Casting

Pol-Ease® 2750 Latex Release Agent is designed specifically for use when casting concrete into latex rubber molds and will result in easier demolding of concrete parts and improved mold life. This formulation performs well with NaturForm Molding Latex Rubbers and does not chemically degrade the molds. This release agent should only be applied to latex molds - do not use on other Polytek® mold materials, including polyurethane and silicone rubbers. 

Brush or spray a thin, uniform coat of release agent on the mold surface. Be careful not to flood or puddle the release on the surface. For best results, brush the released surface with a soft dry brush to pick up excess and ensure uniform coverage. No drying time necessary prior to casting. If there is any doubt about surface preparation, perform a test cure on a similar surface.

This release agent will freeze in cold temperatures and become unusable. Always store and use at room temperature.

FOR INDUSTRIAL/PROFESSIONAL USE ONLY.

NOTE: While Techland takes steps to ensure accuracy in it's product listings and images, any color samples or lamp and product images shown on this website are for reference only, may not be exact and may vary from the actual product look and/or color.

Tell A Friend About: Pol-Ease 2750 Latex Release

Share this great product and savings with others. Note: You and your friend's email addresses are only used once for this recommendation. We do not collect nor store the email addresses.

See all products by PolyTek

2420 Center St, Houston TX 77007 | United States | 832-518-5583