DONE! Item Has Been Added To Your Cart

Your Cookies Are Disabled!

Our site uses first-party Cookies which must be enabled or you will not be able to use the shopping cart. These Cookies are not for ad tracking, are anonymous and have no personally identifiable data - they only hold cart data. [How To Enable]

Lumin's Workshop

Foam Clay Grey 300g

by
(0 Review/s) Write a Review

$20.73

TL Item#: 101231 Category: Mold Making & Casting

Need to add details to your foam armour?

Lumin's Workship has the answer for you! The foam clay starts out as a foamy, putty-like clay that stretches and blends back into itself beautifully.

Once the surface starts drying, it may become hard to smooth lines out, so a TINY bit of water is recommended. Once your piece is finished, leave it to air dry – the bigger the piece, the longer it will take*.

Once fully cured, the foam clay dries into a high density foam which can be cut, sanded, heat formed and glued to your your costume. The cured foam clay pieces do not need to be heat sealed but priming is recommended before painting!

*Lumin's recommends giving it around 48 hours to cure before painting, if your piece is large, the centre may not be fully cured yet. This is normal and you can prime and paint your piece before it's cured on the inside! But you must wait for your piece to be fully cured before cutting and sanding through the surface layer.

NOTE: While Techland takes steps to ensure accuracy in it's product listings and images, any color samples or lamp and product images shown on this website are for reference only, may not be exact and may vary from the actual product look and/or color.

Tell A Friend About: Foam Clay

Share this great product and savings with others. Note: You and your friend's email addresses are only used once for this recommendation. We do not collect nor store the email addresses.

See all products by Lumin's Workshop

2420 Center St, Houston TX 77007 | United States | 832-518-5583