DONE! Item Has Been Added To Your Cart

Your Cookies Are Disabled!

Our site uses first-party Cookies which must be enabled or you will not be able to use the shopping cart. These Cookies are not for ad tracking, are anonymous and have no personally identifiable data - they only hold cart data. [How To Enable]

Hot Wire Foam Factory

Spray-On Foam Glue 14 oz

by
(0 Review/s) Write a Review

$13.95

TL Item#: 75973 MFR Part#: HWFF-028 Category: Foam Coatings

Now you can get fast, strong adhesion without dissolving the foam, as most other spray glues contain solvents that dissolve foam. We have been using and selling this glue since 2002 and have never heard of it dissolving foam when properly used, so it is very likely safe, unlike other "EPS-safe" foam glues that we have used. We used to use and recommend 3M Super 77, but found that in about 18 months it dissolved the foam where the glue was applied. Always apply sparingly. Using too much will weaken bond and could dissolve foam over time. Allow 15-20 seconds before mating sprayed surfaces.

NOTE: While Techland takes steps to ensure accuracy in it's product listings and images, any color samples or lamp and product images shown on this website are for reference only, may not be exact and may vary from the actual product look and/or color.

Tell A Friend About: Spray-On Foam Glue

Share this great product and savings with others. Note: You and your friend's email addresses are only used once for this recommendation. We do not collect nor store the email addresses.

See all products by Hot Wire Foam Factory

2420 Center St, Houston TX 77007 | United States | 832-518-5583