DONE! Item Has Been Added To Your Cart

Your Cookies Are Disabled!

Our site uses first-party Cookies which must be enabled or you will not be able to use the shopping cart. These Cookies are not for ad tracking, are anonymous and have no personally identifiable data - they only hold cart data. [How To Enable]

Hot Wire Foam Factory

Bounce Rubberizer 1 gl

by
(0 Review/s) Write a Review

$69.95

TL Item#: 75970 MFR Part#: HWFF-02BO-Gal Category: Foam Coatings

Incredible Bouncing Boulders? Add small amounts of All Purpose Foam Coat to Bounce to create a flexible protective coating that is highly resistant to cracking on impact. Also makes All Purpose Foam Coat weatherproof, stick even better, and stronger with very thin coats. Use with 1-80 lbs of dry All Purpose Foam Coat.

MIXING: Use Bounce with no added water for maximum flexibility. All Purpose Foam Coat comes out more flexible when no or less water is added to the Bounce.  For a super rubbery coating, try a liquidy mixture of 9 parts Bounce to one part All Purpose Foam Coat, adding the powder to the Bounce, until the desired thickness is attained. Can also be applied alone, or with just a little bit of Foam Coat to create a strong flexible paintable sealant. For a chip resistant coating, start with 1 part liquid to 1 part All Purpose Foam Coat, and thin or thicken as desired.  Dilute the Bounce with water before mixing with Foam Coat to get a less flexible, super smooth, chip-resistant surface. Thin layers can be applied to vertical and inverted surfaces with little or no sagging.
APPLYING: Fill holes with pasty mixture. To coat large areas, make a more liquidy mixture until thin enough to apply with a paint brush. May be applied as thick as 3/8 inch, but multiple coats are stronger. Looks like smooth stone when dry. Try texturing the surface before coating sets. Bounce is compatible with our Grit Texturizers. Can be smoothed while drying, but not sandable once dry.
SET TIME: Use within 15 minutes. Sets up in 30 minutes. Maximum bond and strength in 24 hours.
CLEAN-UP: Immediately clean tools and brushes with soapy water.
FINISHING: Paint or stain as desired.

NOTE: While Techland takes steps to ensure accuracy in it's product listings and images, any color samples or lamp and product images shown on this website are for reference only, may not be exact and may vary from the actual product look and/or color.

Tell A Friend About: Bounce Rubberizer

Share this great product and savings with others. Note: You and your friend's email addresses are only used once for this recommendation. We do not collect nor store the email addresses.

See all products by Hot Wire Foam Factory

2420 Center St, Houston TX 77007 | United States | 832-518-5583